Loading ...
Loading ...
Loading ...
Problem Possible Cause
Engine fails to start
Engine runs erratic 1.
2.
3.
Engine loses power 1.
2.
Excessive vibration 1.
Unit fails to propel 1.
itself
2.
Unit fails to 1.
discharge snow
2.
3.
1. Fuel tank empty, or stale fuel
2. Blocked fuel line
3. Choke not ON
4. Faulty spark plug
5. Key not in ignition switch
6. Spark plug wire disconnected
7. Primer not used properly
Unit running at FULL choke 1.
Stale gasoline 2.
Water or dirt in fuel system 3.
Spark plug wire loose 1.
Gas cap vent hole plugged 2.
Loose parts or damaged auger 1.
Drive control cable not adjusted 1.
Drive belt loose or damaged 2.
Discharge chute clogged 1.
Shear bolt sheared.
Foreign object lodged in auger
Remedy
1. Fill tank with fresh gasoline.
2. Clean the fuel line.
3. Turn Choke knob to ON position.
4. Clean, adjust or replace spark plug.
5. Insert the key fully; do not turn.
6. Attach spark plug wire to the spark
plug on the engine.
7. Prime the engine as instructed earlier.
If the carburetor is flooded due to
over-priming, wait till it dries out.
Turn choke knob to OFF position.
Siphon off existing fuel and fill tank
with fresh gasoline.
Drain fuel tank and carburetor. Fill up
with fresh gasoline.
Connect spark plug wire.
Remove ice and snow from gas cap.
Be certain that vent hole is clear.
Stop the engine immediately and
disconnect spark plug wire. Tighten all
bolts and nuts. If vibration continues,
contact Sears service center.
Adjust drive control cable following
earlier instructions.
Replace drive belt.
Stop engine and disconnect spark
plug wire. Clean discharge chute and
inside of auger housing.
2. Replace shear bolt.
3. Stop engine immediately and
disconnect the spark plug wire.
Remove object from auger.
4. Auger control cable out of adjustment 4. Adjust auger control cable.
5. Auger belt loose or damaged 5. Replace auger belt.
NOTE: This section addresses minor service issues. For further information contact Seats service by calling 1-800-
4-MY-HOME®.
16
Loading ...
Loading ...
Loading ...