Loading ...
Loading ...
Loading ...
ALTERNATE CONNECTION:
If local codes do not permit the
connection of a frame-grounding
conductor to the neutral wire:
STEP 1. Disconnect power.
STEP 2. Make sure the power supply
cord or direct wire cable is in place
(see STEPS 1-3 on page 15 for power
cord connections or STEPS 1-3 on
pages 16-17 for direct wire connection).
STEP 3. Remove the neutral grounding
wire (green/yellow wire) from external
grounding connector screw. Loosen or re-
move terminal block screws. Connect
neutral grounding wire and the neutral
wire (white or center) of power supply
cord or direct wire cable under the center
screw of the terminal block.
STEP 4. Connect the other two wires
to outer terminal block screws. Securely
tighten all electrical connections.
STEP 5. Tighten the strain relief screws.
STEP 6. Insert tab of terminal block cover
into slot of the dryer rear panel. Secure
cover with hold-down screw.
STEP 7. Connect separate copper
grounding wire from external ground con-
nector to an adequate ground. If codes
permit and a separate grounding wire is
used, it is recommended that a qualified
electrician determine that the grounding
path is adequate.
Proceed with Installation on page 24.
External
ground
conne_or
\
\
Neutral
grounding wire
(green/yellow)
Neutral wire
(white)
Grounding path
determined by a
qualified electrician
=_=
Alternate 3-Wire Connection with
External-Grounding Conductor
I8
Loading ...
Loading ...
Loading ...