Loading ...
Loading ...
Loading ...
REVERSE DOOR SWING (OPTIONAL)
You can change your door swing from a right-side opening to a left-side opening, if desired. 7. Attach door hinges to dryer door so that tile larger hole is at the bottom of the hinge.
1. Place towel (A) on top of dryer to protect surface.
2. Open dryer door. Remove bottom screws from cabinet side of hinges (D). loosen (do not
remove) top screws from cabinet side of hinges.
3. I.ifl door until top screws in cabinet are in large part of hinge slot. Pull door forward off
screws. Set door (handle side up) on top of dryer. Remove top screws from cabinet.
4. Remove screws attaching hinges to door.
5. Remove screws at top, bottom and side of door (4 screws). Holding door over towel on
dryer, grasp skies of outer door anti gently lift to separate it from inner door. Do not pry
apart with putty knife. Do not pull on door seal or plastic door catches.
6. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel
to inner door panel so handle is on the side where hinges were just removed.
8. Remove door strike (E) from cabinet. Use a small, flat-blade screwdriver to gently remove
4 hinge hole plugs (F) on left side of cabinet, insert plugs into hinge holes on right side of
cabinet.
9. insert screws into bottom holes on left side of cabinet, lighten screws halfway. Position
door so large end of door hinge slot is over screws. Slide door up so screws are in bottom
of slots. Tighten screws, insert and tighten top screws in hinges.
10. Remove door strike plug (B). Insert the door strike you removed in Step 8 into hole and
secure with screw, insert door strike plug into original door strike hole and secure with
screw.
11. Close door and check that door strike aligns with door catch (C). [f it is needed, slide door
catch left or right within slot to adjust alignment.
Loading ...
Loading ...
Loading ...