Loading ...
Loading ...
Loading ...
You can delay shutdown when the unit is on.
Press the “timer” button, when the unit is on. The screen will display “timer”and “h”,
and the “off ” will flashing. Tap or hold the UP arrow “ ” or the DOWN arrow “ ” to
change delay shutdown timer at 0.5 hour increments up to 10 hours, then at 1 hour
increments up to 24 hours. After 3 seconds, the timer function is enabled, then
“off ” will stop flashing, the display will show the temperature back and the control
will count down the time remaining until shutdown.
To cancel the setting, press the “timer” button again. You can also cancel the setting
E\SUHVVLQJWKH³RQÂRII´EXWWRQ
Plug in the unit, so the unit turns to standby.
Press the “timer” button, when the unit is off. The screen will display “timer” and “h”,
and the “on” will flashing. Tap or hold the UP arrow " " or the DOWN arrow " " to
change delay start timer at 0.5 hour increments up to 10 hours, then at 1 hour
increments up to 24 hours. After 3 seconds, the timer function is enabled, then
“on” will stop flashing, the display will show the temperature back and the control
will count down the time remaining until startup. The unit will start up in the mode as
previously set.
To cancel the setting, press the “timer” button again. You can also cancel the setting
E\SUHVVLQJWKH³RQÂRII´EXWWRQ
Press the “ ” and “ ”button the same time for more than 3 seconds to switch
between degree Fahrenheit and degrees Celsius.
Note: Under Dry/Fan mode, you can not select °F/°C.
function
Timer mode
How to delay startup
How to delay shutdown
Fault Code
Operating Instructions
If the screen on the unit displays “P1”, the water
collection tank inside the unit should be full.
Refer to the "Drainage Instructions" on Page 16
for more instructions to drain the successive
condensate. If error repeats, contact your
Authorize Frigidaire Service Center.
If the screen on the unit displays
“ES”, the pipe temperature sensor
has failed. Contact your Authorize
Frigidaire Service Center.
If the screen on the unit displays
“AS”, the room temperature sensor
has failed. Contact your Authorize
Frigidaire Service Center.
If the display reads "E4" , the communication
between display PCB and main control PCB
is faulty. Contact your Authorized Frigidaire
Service Center.
Loading ...
Loading ...
Loading ...