Loading ...
Fig. 1
Fig. 4
Fig. 3
Fig. 6
Fig. 2
Fig. 5
Helpline: +44 (0) 23 8049 4344 Sales Desk: +44 (0) 23 8049 4333
General Enquiries: +44 (0) 23 8026 6355 Website: drapertools.com
Email: [email protected]
Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire, SO53 1YF, UK
6. With the insert tool at the correct angle,
wind the thread insert into the hole using
light downward pressure until the set
depth is reached and then remove the
insert tool – Fig. 5.
CAUTION! DO NOT work against the
direction of the thread as this may
damage the insert tang.
7. Position the lug breaking tool (E) above
the insert thread tang and strike it to
break the tang – Fig. 6.
3. Care and Disposal
• Clean all parts of the product before and
after each use, and before storing.
• Do not use damaged or defective tools
with this product.
• Store the product in a clean and dry
location, out of reach of children.
At the end of its working life, or when it can
no longer be repaired, dispose of this product
according to local regulations.
Wear eye and face protection
Copyright © Draper Tools Limited
2. Operating Instructions
1. Drill out the damaged thread using the
appropriate drill bit (A) (supplied) – Fig. 1.
Important: Some xings may need to be
removed by a specialist engineer. Draper
Tools accepts no responsibility for the
incorrect removal of broken xings and
fasteners.
2. Use a thread gauge (not supplied) to
ensure that the thread and pitch of the
new fastener are compatible with the
thread insert (F) – Fig. 2.
3. Fix the tapping tool (B) into a tap wrench
(not supplied) and cut a new thread into
the cleared hole – Fig. 3.
Important: Use of an appropriate cutting
oil is recommended. Clear the tapping
tool of chips after use.
4. Use the adjustable ring of the insert tool
(D) to set the depth at which the thread
insert will be positioned and use the hex
key (C) to lock it in place – Fig. 4.
Important: When inserted, the thread
insert should be positioned roughly a
half-turn below the surface.
5. With the thread insert tang positioned at
the bottom, push the insert tool through
the top of the thread insert and locate the
tang in the tang slot.