Loading ...
Loading ...
Loading ...
Pullout Drawer Baskets (some models)
(Door assembly of drawer removed from illustration for
visual clarity)
To remove and replace top basket:
Remove basket by pulling basket out to its full extension
and lift out.
Replace basket by sliding into upper compartment of
freezer.
To remove and replace bottom basket:
Remove basket by lifting basket from rail guides.
Replace basket by placing into rail guides.
Ice Shield (some models)
_i_ The ice shield is mounted at the back of the pullout drawer
_l_to prevent ice from falling behind the basket assemblies.
To remove and replace ice shield:
_ll • Slide ice shield to the right to release hooks (A) from
vertical wire rungs.
To slide tab into shown.
replace, (B) place
as
,,=,
Care and Cleaning
WARNING
Disconnect power to refrigerator before cleaning to
avoid electrical shock which can cause severe
personal injury or death. After cleaning, restore
power.
& CAUTION 'I
Read and follow all manufacturer's cleaning directions
to avoid personal injury or property damage.
General Cleaning
See section on Stainless Steel Cleaning if doors are
stainless steel.
1. Wash surfaces with 4 tablespoons baking soda
dissolved in 1 quart warm water and a soft, clean
cloth.
2. Rinse surfaces with warm water. Dry surfaces with a
soft, clean cloth.
• Do not use the following items:
- abrasive or harsh cleaners, ammonia,
chlorine bleach, etc.
- concentrated detergents or solvents
- metal scouring pads
These items can scratch, crack and discolor sur-
faces.
• Do not place buckets, shelves, etc. in dishwasher.
Stainless Steel Cleaning
Damage to stainless steel finish due to improper use of
cleaning products, or using non-recommended
cleaning products, is not covered under warranty.
1. Wash surfaces with warm soapy water and a soft,
clean cloth or sponge.
2. Rinse surfaces with warm water. Dry surfaces with a
soft, clean cloth.
• Do not use the following harsh cleaners:
- abrasive or acidic cleaners (ammonia, chlorine
bleach, vinegar-based product, etc.
- citrus-based cleaners
- scouring pads (metal, textured plastic, etc.)
These items can scratch, discolor, or permanently
tarnish surfaces.
3. Follow up rinsing by immediately drying with a soft,
clean cloth. This will avoid water spotting on
stainless steel finish.
Adhesives
1. Remove adhesive residue from refrigerator surfaces
by rubbing toothpaste into adhesive with fingers until
adhesive loosens.
2. Rinse surface with warm water. Dry surface with a
soft, clean cloth.
Door Gaskets
1. Clean door gaskets every 3 months according to
General Cleaning instructions. Clean any spills
immediately.
]d
Loading ...
Loading ...
Loading ...