Loading ...
Loading ...
Loading ...
SECTION3: ASSEMBLINGYOURLAWNMOWER
RemovingUnitFromCarton
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open.
Remove loose parts included with unit (i.e.,
operator's manual, oil, etc.).
Cut corners and lay carton down flat. Remove
packing material.
Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
NOTE: Make sure not to crimp cables while removing
loose parts or the entire unit from the carton.
ToolsRequired
Pair of Pliers
Funnel
NOTE: Reference to right or left hand side of the mower
and/or front or behind the mower is observed from the
operating position.
HardwarePack %
Please identify each piece of the
hardware pack as shown in
Wing Carriage
figure here, Nut(2) Bolt (2)
DisconnectingSparkPlug
Before setting up your lawn mower, disconnect the
spark plug wire from the spark plug, and ground it
against the engine.
AssemblingHandle
Remove grass bag from the unit and set it out of the
way. See Figure 1 (step 1).
Remove any packing material which may be
between the upper and lower handles for shipping
purposes.
2. Lift lower
handle
1. Move bag
away
3. Lift upper
handle
Figure 1
Raise the lower handle inthe direction shown in
Figure 1 (step 2) till it snaps into place.
Raise the upper handle in the direction shown in
Figure 1 (step 3). Tighten the wing nuts which are
already on the handle. See Figure 2.
._ Upper Handle
Lower Handle
Tightenthis
_ wing nut
Figure 2
NOTE: Make sure to route the cables inside the lower
handle. Also do not crimp the cables while lifting the
handle up.
For shipping purposes, the hairpin clip is placed in
the outer hole of the weld pin on the lower handle.
Remove the hairpin clip from the outer hole of the
weld pin. See Figure 3.
Using a pair of pliers, insert the hairpin clip intothe
inner hole on the weld pin. Repeat on other side.
See Figure 3.
\
Wire
Handle
Mounting Bracket
Hairpin Cli! _"
I Pin
Figure 3
Insert the carriage bolt, included in the hardware
pack, in the upper hole on the handle mounting
bracket (carriage bolt must go to the inside of
handle). Secure with one plastic wing nut, also
included in the hardware pack. Repeat on the other
side with remaining items from the hardware pack.
Attach cables to the lower handle with the two cable
ties already on the lower handle. Insert pegs on
cable ties into the holes on the lower handle. Pull
cable ties tight and cut off the extra.
Loading ...
Loading ...
Loading ...