Loading ...
Loading ...
Loading ...
Top Rack Only
For added convenience, use for washing
a small load of dishes in the top rack to
help keep the kitchen continuously clean.
Available with
any cycle
Cannot be used
with TURBOZONE ®
option
Slightly faster wash for
smaller loads
-7 -3O
SmartDry TM or Heated Dry
(on some models only)
Turnsthe heat element on, with fan assist
(on some models), at the end of the
wash cycle. Use rinse aid with or without
the SmartDry TM or Heated Dry option
for best drying results. Plastic items are
less likely to deform when loaded in the
top dish rack.
Available with
any cycle except
Quick Rinse
Turns the heat element on
at the end of the wash
cycle.
44
Selecting multiple options does not result m accumulative time and water from chart above.
51 0
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak
hours when possible.
To delay the start:
1. Select a wash cycle and options.
2. Press the Delay button.
3. Press START/RESUME.
NOTE: Anytime the door is opened for more than 5 seconds (such as, to add a dish), the Start/Resume button must be pressed
again to resume the delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When Locked is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on Control Lock..
Press and hold TOP RACK ONLY for 3 seconds. Locked will light. If you press any pad while your dishwasher is locked, the light
flashes 3 times.
NOTE: The dishwasher cannot start if the control is locked.
To turn off Control Lock
NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL/DRAIN, or by opening and closing
the door before you are able to turn off Control Lock.
Press and hold TOP RACK ONLY for 3 seconds. The lights turn Off.
Indicators and Countdown Bar (on some models)
The indicators will inform you if you are able to add a dish to the cycle after it started. It
will also inform you if the dishwasher is washing, rinsing, drying, complete, and/or
sanitized. They will show whether the control is locked and/or the delay option is selected.
A series of bars will count down the duration of the cycle remaining from left to right. Each
bar equals approximately 24 minutes of cycle length.
Selecting Cycles and Options
1. To repeat the same cycle/options used on previous cycle, press START/RESUME once to show which selections you used. To
change cycle, select desired cycle.
2. Select the desired options, then press START/RESUME to start the cycle. Not all options are available for every cycle. If an
invalid option is selected for a given cycle, the lights will flash.
Loading ...
Loading ...
Loading ...