Loading ...
Loading ...
Loading ...
14
newair.com
• When the container is almost
full, replace the rubber plug in
the drain hole and empty the water tray.
• Repeat until the unit is emptied.
• Replace the rubber plug and tighten the drain knob firmly.
• Switch on the unit - the full water or compressor operating indicator
should
not be flashing.
Should you prefer to use the appliance without having to empty the
tank every so often, proceed as follows:
• Remove the drain knob and rubber plug
and retain for future use.
• Connect the drain tube supplied to the
water outlet as shown and locate the other end into a drain.
• The drain tube may be extended by adding
an extension tube and using a suitable
connector.
Please note:
• The drain must be at a lower level than
the drain hole on the unit.
• Flashing Water Full indicator will not
function in this mode of drainage.
• If you want to extend the water tube, you
can connect it with
another tube (OD: 0.7” / 18mm)
Loading ...
Loading ...
Loading ...