Loading ...
Loading ...
Loading ...
EN
©2021 Hestan Commercial Corporation
13
INSTALLATION OF DISPENSING EQUIPMENT
(continued)
1. Locate the dispensing head , black
beer line(s), and hose clamp(s). Slide
one end of each beer line onto the
stainless steel tubes which protrude
out the bottom of the dispensing head
and clamp tight.
2. Remove transit tape with a utility
knife around the hole in the top of the
unit from both inside and outside of
the cabinet. Gently punch out foam
w/screwdriver and remove. Insert
the beer line(s) through the hole in
the countertop. Move head aside
and apply a bead of silicone around
perimeter of hole, and then position
the head back in place. Fasten using
the 4 chrome screws included with
the dispensing head. Wipe off excess
silicone to complete the seal.
3. Use the 3/8” -thick foam pad included
in the tapping kit and roll into a
cylinder. From inside the cabinet,
insert the foam tube up through the
hole in the countertop until it is firmly
against the insulation in the dispensing
head. Mark, then cut away any excess
foam.
Loading ...
Loading ...
Loading ...