Loading ...
Loading ...
Loading ...
10
BURNER ADJUSTMENT
Each burner is tested and adjusted at the factory prior to shipment; however, variations in the local gas supply may make it
necessary to adjust the burners. The flames of the burners (except the rotisserie infrared and TruSear
TM
infrared burner) should
be visually checked and compared with Fig. 1, Fig. 2, and Fig. 3.
Flames should be blue and stable with no yellow tips, excessive noise or lifting. If any of these conditions exist, check if the air
shutter or burner ports are blocked by dirt, debris, spider webs, etc. With a proper flame height, adjust the air shutter to
obtain a blue flame with no yellow tipping that sits on the burner at the burner ports. The air shutter is locked in place by a set
screw which must be loosened prior to lighting the burner for adjustments.
To access the air shutter on the grill burners and smoker burner, remove the valve panel. To access the air shutter on the side
burners, remove the grates, burner bowls, and grate support. With a screw driver, loosen the lock-screw on the face of the air
shutter. Light the burner and adjust according to the directions below.
1. If the flame is yellow, turn the air shutter counter clockwise to allow more air to the burner.
2. If the flame is noisy and lifting away from the burner, turn the air shutter clockwise to reduce the amount of air to
the burner.
Once adjusted, turn the burner off, tighten the set screw on the air shutter, replace the valve panel for the grill burners and the
grate support, burner bowls, and grates for the side burners.
To ensure proper installation of the grill burners, side burners, and smoker burner:
1. Slide opening in air shutters over the orifice located in the front of the grill.
2. For the smoker burner, secure back of the burner by placing over screw slot on rear of grill and replacing screw.
INITIAL IGNITION OF BURNERS
All burners are tested before leaving the factory. Field adjustments may be necessary for proper mixture of gas and air
for proper operation. When the grill is connected to the gas service, it should be adjusted by a qualified technician.
For lighting instructions, refer to the Outdoor Gas Grill Use and Care Manual.
Orifice
1/2”
(1.3 cm)
3/8”
(0.95 cm)
Air
Shutter
Fig. 1
GRILL BURNER
Loading ...
Loading ...