Loading ...
Loading ...
Loading ...
How To Install The Speed Control Rod
1. Put the speed select lever intothe
sixth gear position.
2. Attach the speed control rod (end
with 90 °bend) to the speed select
bracket with washer and cotter
pin. See Figure t0.
3. Put the speed select lever intothe Bracket
first gear position.
4. Attach the ball joint, located on the
bottom end of the speed control
rod, to the shift yoke assembly.
See Figure 11. The fasteners are Speed
attached to the ball joint at the Control
factory. Rod
5. The length ot the ball joint and
speed control rod have been pre-
adjusted at the factory, if an adjust-
ment is required, loosen the nut.
Remove the fasteners to discon-
nect the ball joint from the shift Nut _'_'
yoke assembly. To lengthen or
shorten the speed control rod, turn Adapter
the adapter to obtain the correct
length.
6. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Joint
Speed Select
Lever
Cotter Pin
Figure 10
Shift Yoke
Assembly
\\ Fasteners
\\. Figure 11
How To Assemble The Chute Deflector
1. Remove the carriage bolt. See
Figure 12.
2. Raise the chute deflector into op-
erating position.
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
4. Fasten with washer and Iocknut.
5. Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERT|GHTEN.
Chute
Deflector
Carriage,_
Bolt
F-031001L
10
Washer Nut
Figure 12
Loading ...
Loading ...
Loading ...