Loading ...
Loading ...
Loading ...
Wall Sleeve Brands:
#6 Whirlpool 17=1/8" Deep
1. Remove existing rear grille as shown on Page 3 of this manual and
replace with provided Iouvered rear panel. Install as shown here.
NOTE: You may need to drill holes in flange of existing sleeve to match
new rear grille
80 ° \
Rear Louvers
Top View
2. Cut (2) 17" Tapered Spacer Blocks as shown below into two pieces.
17"
3/4. I _aperedSpacer Block
\
Cut Here _ 13" \
1"
protection Paper Backing
3. Install to the floor of the sleeve as shown. This helps induce a rearward
slope on the unit.
4. Attach (1) l"x 3/8" x 25" long seal in the center at the top of the sleeve.
Remove the backing paper and press into position.
5. Attach (2) l"x 3/8"x 14" seals to the left and right sides of the sleeve.
6. Cut (2) 1" x 3/8"x 25" long seals to 14" long each and attach to the
vertical sections of the grille as shown.
7. Center unit & gently slide unit into sleeve.
8. Before sliding all-the-way back, remove 2nd screw from front on left
side of unit.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground wire from sleeve to the unit
as shown in picture. Make sure that the toothed washer is against the
cabinet.
11. Slide the unit completely to the rear to ensure a good seal, making sure
the ground wire does not become tangled.
12. Seal & Frame the unit as described on the last page of these instructions.
13. If you have difficulty with mounting the grill to the sleeve, follow the
instructions for direct mounting on Page 13.
Loading ...
Loading ...
Loading ...