Loading ...
Loading ...
Loading ...
8. Blade Assembly.
7. Canopy Assembly.
page 6
canopy set screw
canopy
Raise canopy to hanging bracket until
canopy touches the ceiling. Tighten the
canopy set screw to secure canopy.
Carefully remove protective paper from
downrod.
Remove protective film from both sides
of blade.
Locate one of the rubber cushions on
top of motor housing. Remove the
2 larger screws (do not remove center
screw) and washers but leave rubber
cushion intact.
Lower blade over rubber cushion--note
label on blade indicating THIS SIDE UP.
Attach blade with screws and washers
that were previously removed. Tighten
screws securely.
Repeat Section 8 with each of the
remaining blades.
blade
(remove
protective film)
motor
housing
larger screws
and washers
downrod
Loading ...
Loading ...
Loading ...