Loading ...
Loading ...
Loading ...
PURESOURCE2 TM* iCE AND WATER FRONT FILTER
(SOME MODELS}
Also, if the filter has been in a refrigerator that has not been in
use for awhile (during moving for example), change the filter
before reinstalling the refrigerator. The dispenser system will also
operate without filtration (with filter cartridge removed and bypass
installed).
System Startup:
Water supply does not need to be turned off, however, do not
use ice and water dispenser while installing filter.
The filter cartridge has already been installed in the filter
housing at the factory. Refer to the How to PHme the Water
Supply System section to properly filI the system with water.
To change filter:
It is not necessary to turn the water supply off to change the
filter.
1. Turn OFF side mounted ice maker by raising wire signal
arm to the UP position. Turn OFF rear mounted ice maker
by pressing ON/OFF power switch to the "O" position.
2. Push the Filter Release Button, located to the right of the
filter cartridge, to release the filter from the housing. To
minimize the possibility of the filter falling out of the
housing during removal, it would be best to hold the
filter as it moves out toward you.
Order new filter
cartridges through the
dealer where you
bought the refrigerator,
contact the Electrolux
Solutions Hot1.ine at 1-
800-944-9044, or go to
our web site at
www.frigidaire.com. It
might be good to order
some filter cartridges
when you first install
your refrigerator. Be
sure to ask for the FC-
100 PureSource TM*
replacement cartridge.
and Click Push
ToInstall ToRe!ease
The PureSoume2 rM"Ice and Water Filter
System NGFC 2000 with the PureSource2 Tu"
cartridge FC 100 is tested and certified by
NSF International, the nationally recognized
and respected, not for profit, certification
organization for public health safety. The PureSoume2 rM*
Filter system is tested and certified to ANSI/NSF Standards
42 and 53. See performance data sheet for specifications.
This system should not be used on water that is
microbiologicaliy unsafe or with water of unknown quality
unless the water has been adequately disinfected before or
after traveling through the filtration system.
,, Rated Capacity - 400 gallons
,, Rated service flow - .5 GPM
,, Maximum Rated Pressure - 100 PSI
,, Maximum Operating Temp. - 100 ° F
3. Pull the old filter cartridge straight out of the housing.
4. Discard the old filter.
5. Remove the new filter cartridge from the packaging and
insert into the filter housing the same way the old one
came out.
6. When the cartridge is almost in, you wilI feel it stop against
the clip assembly in the back of the housing. The clip
assembly holds the filter cartridge firmly in piace. At this
point, you wiII need to push firmly until the cartridge
snaps fully in place. When completely in place, the front of
the filter cartridge wilI be flush with the front of the housing.
7. Turn ON side mounted ice maker by lowering wire signal
arm to the DOWN position. Turn ON rear mounted ice
maker by pressing ON/OFF power switch to the '1"
position.
8. Fill a glass with water. As you are doing this, check for
leaks at the filter housing.
9. To prime filter system and purge air from water mine,
continue flushing the system for approximately 3 minutes
to assure that the purest water possible is stored in the
water tank. There will be noticeable spurts and sputters
as the system pushes air out through the system and
out the dis This is normal
Changing the Filter:
Water conditions vary throughout the world, but changing the
water filter every 6 - 9 months normally witl ensure the highest
possible water quality, ice jams in the ice maker and/or
hollow ice cubes (partially frozen cubes with water inside},
may also be a sign that your water filter needs changing.
The Filter Status Iight will turn red after approximately 400
galJons of water has flowed through the ice and water dispenser.
* White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same fiIter.
19
Loading ...
Loading ...
Loading ...