Loading ...
Loading ...
Loading ...
Cancelling or modifying a wash cycle setting...
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have
already been released, and the appliance may have already drained the wash water, if this is the case, the detergent dispenser
must be refilled (see the paragraph entitled " Loading the Detergent " ).
Press the ON/Ot:t: button, and the ON light wilt turn off. Rotate the dia! in the clockwise direction to the desired cycle setting (see
the section entitled " Starting a wash cycle... " ). Then, turn the dishwasher back on using the ON/Ot F button.
At the End of the Wash Cycle
When the dial stops turning and is aligned with the STOP mark(see figure), the cycle has finished.
Turn offthe appliance using the ON/OFF button, shut offthe water supply and open the door of
the dishwasher. Wait a few minutes before unloading the dishwasher to avoid handling the
dishes and utensils while they are still hot and more susceptible to breakage.
Forget to Add a Dish?
A forgotten dish can be added any time befbre the detergent cup opens.
Pull the door handle.
Do not open the door until the water spray action stops. Steam may rise out of the dishwashm_
Add forgotten dishes.
Push the door to close. When the door is properly closed, a click wilt sound.
FILTERING S YS TEM
ii;2
ii;!:3
Main filter
Food and soil particles trapped by this filter are pulverized by a special jet on the lower
spray arm and washed down the drain.
Coarse filter
Larger items, such as pieces of bone or glass, that could clog the drain are trapped in the
coarse filter. To remove an item caught in this filter, gently squeeze the tabs on top of this
filter and lift it out.
Fine filter
This filter holds soil and food residue in the sump area and prevents it from being
redeposited on the dishes during a cycle.
CARING FOR THE DISHWASHER
Protect Against Freezing
if your dishwasher is left in an unheated place during the winter, ask a service technician to:
Cut off electrical power to the dishwasher
and remove fhses or trip circuit breaker.
Turn off the water supply and disconnect the
.... water inlet pipe fl'om the water valve.
Drain the water from the inlet pipe and water valve.
(Use a pan to catch the water.)
Reconnect the water inlet pipe to the
water valve.
{__ Remove the plastic sump cover in the
tub the bottom and use a sponge to
soak up the water in rubber boot.
Loading ...
Loading ...
Loading ...