Loading ...
Loading ...
Loading ...
en Rinse aid system
24
Additional run time in minutes 7
Additional water consumption in
litres
5
Additional power consumption in
kWh
0.05
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard and using the
Eco 50° programme and the factory
value of the water hardness is set to
9 - 20°E.
Rinse aid system
Rinse aid system
Rinse aid system
Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
1. Press the catch on the lid of the
dispenser for rinse aid
and lift
.
1
2
2. Add rinse aid up to the max mark.
max
3. If rinse aid spills out, remove it
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
4. Close the lid of the dispenser for
rinse aid.
a The lid clicks into position.
Setting the amount of rinse
aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
1. Press
.
2. To open the appliance settings,
press
for 3 seconds.
a
is flashing on the display.
3. Press
repeatedly until
flashes.
4. Press
repeatedly until the
right amount of rinse aid has been
set.
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
The factory setting is level 2 ("LED
A and LED B" →Page15).
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
Loading ...
Loading ...
Loading ...