Loading ...
Loading ...
Loading ...
30
Installation Test (Exhaust check)
Once you have completed the installation of the dryer,
use this test to make sure the condition of the exhaust
system is adequate for proper operation of the dryer.
This test should be performed to alert you to any serious
problems in the exhaust system of your home.
t:PVSESZFSGFBUVSFT'MPX4FOTF™, an innovative sensing
system that automatically detects blockages and
SFTUSJDUJPOTJOESZFSEVDUXPSL,FFQJOHEVDUXPSLDMFBO
of lint buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
5PBDUJWBUFUIFJOTUBMMBUJPOUFTU
3FNPWFUIFMJUFSBUVSFBOEUIFODMPTFUIFEPPS
Do not load anything in the drum for this test, as in
may affect the accuracy of the results.
1SFTTBOEIPMEUIF5FNQ$POUSPMBOE4JHOBM
CVUUPOTBOEUIFOQSFTTUIF1PXFSCVUUPO
This button sequence activates the installation test.
The code
will display if the activation is
successful.
1SFTT4UBSU1BVTFCVUUPO
The dryer will start the test, which will last about
two minutes. The heat will be turned on and the
temperatures in the drum will be measured.
$IFDLUIFEJTQMBZGPSSFTVMUT
During the test cycle, monitor the Flow Sense™
display on the control panel. If no bars are displayed,
when the cycle ends, the exhaust system is
adequate. If the exhaust system is severely restricted,
the display will show four bars. Other problems may
also be shown with error codes. Refer to the next
page for error code details and solutions.
Four bars indicates that the exhaust system is severely
SFTUSJDUFE)BWFUIFTZTUFNDIFDLFEJNNFEJBUFMZBT
performance will be poor.
&OEPGDZDMF
At the end of the test cycle,
will display.
The test cycle will end and the dryer will shut off
automatically after a short delay.
/P#BST0L'PVS#BST
Restricted
NOTE
The dryer should be cool before starting this test. If
the dryer was warmed up during installation, run the
Air Dry cycle for a few minutes to reduce the interior
temperature.
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...