Loading ...
Loading ...
Loading ...
AIR FILTER MAINTENANCE
Removing the Air Filter/Muffler Cover
WARNING: Toavoidserious
personal injury,
always turn the unit off and allow it to cool
before you clean or service it.
1.
Remove the four (4) screws secuhng the air
filter/muffler cover (Fig. 13). Use a flat blade or # T20
Torx bit screwdriver.
2. Pull the cover from the engine. Do not force.
ScFews
EZ FireTM
Lever
Screws
/
Air Filter
J
_ Inside Muffler
Cover
Fig. 14
Fig. 15
Fig. 13
Cleaning the Air Filter
Clean and re-oil the ak filter every 10 hours of operation.
[t is an important item to maintain. Failure to maintain the
air filter will VOID the warranty.
1. Remove the air filter/muffler cover. Refer to the
Removing the Air filter/Muffler Cover section.
2. Remove the air filter from inside the air filter/muffler
cover (Fig. 14).
3. Wash the filter in detergent and water (Fig. 14). Rinse
the filter thoroughly. Squeeze out excess water.
Allow it to dry completely.
4. Apply enough SAE 30 oil to lightly coat the filter (Fig. 15).
5. Squeeze the filter to spread and remove extra oil (Fig. 15).
6. Replace the air filter inside the muffler cover (Fig. 14).
NOTE: Operating the unit without the air filter and cover
assembly will VOID the warranty.
Reinstalling the Air filter/Muffler Cover
1. Place the air filter/muffler cover over the back of the
carburetor and muffler.
2. Insert the four (4) screws into the holes in the air
filter/muffler cover (Fig. 13) and tighten. Use a flat
blade or # T20 Torx bit screwdriver. Do not over
tighten. Do not force.
SPARK ARRESTOR MAINTENANCE
1. Remove the air filter/muffler cover. Refer to
Removing the Air Filter/Muffler Cover.
2. Locate the muffler front and the two (2) bolts securing
it to the engine (Fig. 16). Remove the two (2) bolts
using a flatblade screwdriver or 5/16-inch socket or
nut driver. Pull the muffler off of the engine.
3. Turn the muffler over to the back side and locate the
exhaust gasket. Remove the muffler gasket from the
muffler (Fig. 16).
NOTE: Ifthe exhaust gasket is torn or damaged, replace it
with a new gasket before you reassemble the muffler.
4. Using a small flatblade screwdriver, carefully pry up
the spark arrestor from the recessed hole (Fig. 17).
Remove the spark arrestor from the muffler.
5. Clean the spark arrestor with a wire brush. Replace it if it
is damaged or if it can't be cleaned thoroughly (Fig. 17).
6. Reinstall the spark arrestor by pressing it into the
recessed hole on the muffler's back side. Make sure
it fits tightly against the muffler and is not raised up.
7. Place the exhaust gasket against muffler's back side.
Align the gasket bolt holes with the bolt holes in the
muffler. While holding exhaust gasket in place, insert
the bolts into the muffler's front side (Fig. 16).
13
Loading ...
Loading ...
Loading ...