Loading ...
Loading ...
Loading ...
General Care & Cleaning (cont'd)
Fig.2
L..............................................................
Oven
Door
Fig. 3
Oven
Wire.
Holder
Fig. 4
Door Hinge
locations
with oven door
fully open
Fig. 1
Removing and Replacing the Lift-Off Oven Door
The door is heavy. For safe, tempo rary storage, lay the door flat with the
inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor- See Fig. 1).
2. Pullthedoorhingelocks on both left and rightdoor hingesdown from the oven frame
completely towards the oven door (See Fig. 2). A tool such as a small flat-blade
screwdriver may be required.
3. Firmlygrasp both sides of oven dooralong the door sides (Do not use the oven door
handle - See Fig. 3).
4. Close the door to the broil stop position (the oven door will stop into this position
just before fully closing).
5. With the oven door in the broil stop position, lift the oven door hinge arms over the
roller pins located on each side of the oven frame (See Fig. 4).
To Replace Oven Door:
1. Firmlygrasp both sides of oven dooralong the door sides (Do not use the oven door
handle - See Fig. 3).
2. Holding the oven door at the same angle as the removal position, seat the hook of
the hinge arm over the roller pins located on each side of the oven door frame (See
Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with floor- See Fig. 1).
4. Push the door hinge locks up towards and into the oven frame on both leftand right
oven door hinges (See Fig. 2) to the locked position.
5. CIosethe oven door.
Special Door Care Instructions- Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are fully in place.
2. Do not hit the glass with pots, pans, or any other object.
3. Scratching, hitting, jarring or stressing the glass may weaken its structure causing
an increased risk of breakage at a later time.
Care & Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and
cleaning are required for maintaining the appearance of stainless parts. Refer to
the Cleaning Table at the beginning of this section for detailed cleaning
instructions.
Changing the Oven Light (some models)
For models equipped with the interior oven light, the light bulb is located at the
rear of the oven and is covered with a glass shield held by a wire holder (See Fig.
5). The glass shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock will then need to be reset. To reset, see Setting the Clock &
Minute Timer in this Use & Care Guide.
Fig. 5
Be sure the range isunplugged and all parts are COOL before replacing
oven light. Wear a leather-faced glove for protection against possible broken glass.
13
Loading ...
Loading ...
Loading ...