Loading ...
Loading ...
Loading ...
@
Low: Use to simmer foods, keep foods
warm and meritchocoHateor butter. Some
cooking may take pHaceon the Low
setting if the pan is covered. It is possibHe
to reduce the heat by rotating the knob
toward OFF. Be sure flame is stabile.
High: Use to bring hquid to a boiH,or reach
pressure in a pressure cooker. AHways
reduce setting to a Howerheat when Hiquids
begin to boiHor foods begin to cook.
An intermediate flame size is used to
continue cooking. Food wiHHnot cook any
faster when a higher flame setting is used
than needed to maintain a gentile boil
Water boiHsat the same temperature
whether boiHinggentHyor vigorousHy.
Surface Controls
• If flame shouHdgo out durung a cooking operation, turn
the burner off. If a strong gas odor is detected, open a
window and wait five minutes aetore relighting the
burner
o Be s_re aiHsurface controls are set in the OFF position
prior to supplying gas to the range.
- @EVERtouch cooktop until it has cooled, Expec_some
parts of the cooktop, especiaii} around the burners, to
become warm or hot during cooking, Use potholders to
Pilotless Ignition
PiHotHessignition eHiminatesthe
need for a constant standing
piHotHight.Each surface burner
has a spark ignitor. Use care
when cleaning around the
surface burner.
[f the surface burner does
not Hight,check if ignitor is
broken, soiled or wet.
BURNER CAP
Ports
gnitor
BURNER BASE
Surface Control Knobs
Use to turn on the surface burners= An infinite choice of heat
settings is available from Low to High. At the High setting a
detent or notch may be felt. The knobs can be set on or
between any of the settings.
Graphics next to the knob identify which burner the
0 0 knob controls. For example, the graphic at Heftshows
0 0 the Heftfront burner location.
Setting the controls:
The size and type of cookware will affect the heat setting. For
information on cookware and other factors affecting heat
settings, refer to "Cooking Made Simple" bookieL
1. Place a pan on the burner grate.
" The burner flame may lift off or appear separated from
the port if a pan is not placed on the grate.
2. Push in and turn the knob counterclockwise to the Light
setting.
o A clicking (spark} sound wiil be heard and tile burner
wiil Hight. (AHIfour ignitors wiil spark when any surface
burner knob is turned to the Light position.}
3oAfter the burner lights, turn knob to desired flame size.
The ignitor wiil continue to spark until the knob is
turned past the Light position.
Operating During a
Power Failure
When lighting the surface burners, be sure alHof the
ControHsare in the OFF position, Strike the reatchfirst and
hoHdit in position before turning the knob to Light,
1. HoHda Hightedmatch to the desired surface burner head.
2. Push in and turn the controHknob showilyto Light.
3. Adjust the flame to the desired Hovel
5
Loading ...
Loading ...
Loading ...