Loading ...
Loading ...
Loading ...
About the storage drawers, gecom
Not aft features are on all models.
Snacks Drawer
The snacks drawer can be moved to tim
most useflfl location for your family's
needs.
About storage drawer and cover removal.
Not all features are on all models.
Humidity Control
HIGH LOW
Adjustable Humidity Drawer (onsomemodels)
Slide the control all die way to the Slide the control all die way to the LOW
HIGHsetdng to provide high humidity setting to provide lower humidity levels
recommended for most vegetables, recommended for most fl_uits.
Drawer and Cover Removal
Drawers can be removed easily by grasping the sides and lifting tap slighdy while pulling
drawers past the stop location.
Full-Width Drawer with
Plastic Cover
Toremovethecover,lift it off its supports,
pull it forward, tilt it and rake it out.
Twin Drawer Shelf
Toremove:
[-'7] Remove tile drawers.
[_-] Reach in, push the flont of glass cover
up, and at tile same time, pull it forward
as far as it will come.
Tilt it and take it out. Avoid cleaning the cold
glass covet" with hot water becmlse the exu'eme
temperature ditference mW cause it m break.
[-_] Remove tile drawer fl_une. (Always
remove tile ,glass cover before you rake
out the drawer fiame.)
Lift the fi'mne off the supports at each side
and back, pull it forward, flit it and take it out.
Toreplace:
F_ Lower the frame until it restson the
supports at each side and back.
[_--]Replace tile glass covet; pushing its rear
edge firmly into the rear flame channel
and gendy lowering tile flont into place.
[j] Replace tile drawers.
About the automatic icemaker.
A newly-installed refrigerator may take 12to 24 hours to begin making ice.
ij)(( j ¸/i/
,qerArmin
le STOP
FeelerArmin (Up)position
theON(down)
position
Automatic Icemaker (onsomemodels)
The icemaker will produce approximately
100-130 cubes in a 24-hour period,
depending on the fl'eezer compai'unent
temperature, room temperature, number of
door openings mad other ttse conditions.
If the refl'igeramr is operamd before the water
connection is made to the icemaket; move tile
feeler arm to the STOP(up) position.
When the refrigerator has been connecmd
m the wamr supply, move tile feeler am1 m
the ON (down) position.
You will hear a buzzing sound each time
the icemaker fills with wamt.
The icemaker willfill with water when it cools
to 15°E A newly-installed refi'igerator mW rake
12 m 24 hours to begin making ice cubes.
Throw away the fi_t few batches of ice m
allow the wamr line m cleat.
Be sure nothing inmrferes with the sweep
of the feeler arm.
When the bin fills m the level of the feeler
arm, the icemaker will stop producing ice.
It is normal for several cubes m be joined
together.
If ice is not used fiequendy, old ice cubes
will become cloudy, tasm stole and shrink.
NOTE:Inhomeswithlower-than-averagewater
pressure,youmayheartheicemakercyclemultiple
timeswhenmakingonebatchofice.
Icemaker Accessory Kit
If your refi'igerator did not ah'eady come
equipped with an mltomafic icemaket; an
icemaker accesso W kit is available at extra cost.
Check the back of the refligerator for
tile specific icemaker kit needed for
your model. 5
Loading ...
Loading ...
Loading ...