Loading ...
Loading ...
Loading ...
Fe_ _ufe$ Cyde 5ignai
A signal will sound at the end of tile cycle and )eriodically during Wrinkle-Rid.
Drum Light
A drum light will come on whenever the door _sopened to illuminate the dryer
drum during loading and unloading. Closing the door turns off the light.
Reversible Dryer Door
Your dryer is equipped with a reversible door. The door carl be hinged on the
right or left side. Refer to the INSTALLATION INSTRUCTIONSfor directions
on changing the door.
Place the front bar under
the lip of the lint screen opening
Drying Rack
Use the drying rack to dry items which should not be tumble dried.
I. Open the dryer door and remove the lint screen.
2. Insert drying rack into tile dryer drum. Placethe front bar under the lip of
tile lint screen opening.
3. Place items to be dried on top of the rack. Weight should not exceed 10
Ibs. Leave space between items, but do not let items hang over tile sides
or through the grids. Do not tumble other items when using the drying
rack.
4. Select Time Dry. Use only tile No Heat option for items containing plastic,
foam rubber, rubberqike materials, feathers or down.
5. When items are dry, remove the rack and replace the lint screen. If lint
screen is not in place, tumbling items could enter the exhaust system and
cause damage to the dryer.
Common Drying Probiems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric
damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
PROBLEM
Greasy, oily
stains
Lint
Pilling
(Fibers break
off, ball up and
cling to fabric)
Shrinking
Wrinkling
POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES
Fabric softener sheet,
Overloadin%
Overdrying causes static
electricity_
Lint screen not clean
when cycle began
Lint is attached to "pills"
Rub fabric softener stains with bar
soap, Rinse and rewash
Reduce load size and rewash using
liquid fabric softener in the final rinse
Or, add a fabric softenersheet and
tumble without heat
Uselint brushor roller to remove lint,
Add a few bath towels to small loads for
proper tumbling
Some "silk4ike" fabrics should be air
dried
Use proper drying temperature
Place fabric softener sheet on top of load
before starting the dryer_
Do not overload dryer.
Use fabric softener in washer or dryer to
reduce static electricity.
Remove items when they are slightly
damp to avoid overdrying
Check that lint screen is clean and in
place
Pilling is normal with
synthetic and permanent
press fabrics_ This is due
to abrasion from normal
wear_
Use a lint brush or shaver to remove
pills,
Use fabric softener to lubricate fibers_
When ironing, use spray starch or fabric
finish on collars and cuffs_
Turn items inside out to reduce abrasion
Overdrying
Overloadin%
Leaving items in dryer
after cycle ends,
Irreversible condition,
Reduce load size and tumble at
medium or low heat for 5-10 minutes_
Remove items immediately Hang or
fold, 6
Follow fabric care label directions
If shrinking is a concern, check load often.
Remove items while slightly damp and
hang or lay flat to complete drying_
Block knits into shape_
Do not overload dryer_
Remove items as soon as cycle ends
Loading ...
Loading ...
Loading ...