Loading ...
Loading ...
3
MOUNTING THE GARAGE PARKING SENSOR
TESTING THE GARAGE PARKING SENSOR
SETTING THE STOPPING DISTANCE
Drive your car slowly into the garage. As your car approaches the
Sensor, the Display Light illuminates green, then yellow and finally red
when you should completely stop your car.
Important: The Garage Parking Sensor is designed to aid in slow-speed
parking only. Always follow safe driving procedures when parking your car.
The Garage Parking Sensor has 3 selectable stopping distances -
1,2 and 3 feet. To set the stopping distance, slide the switch on the
rear of the Sensor to the desired stopping distance.
Note: Measurements shown above are approximate. Actual stopping
distances may vary due to environmental factors (wind, air temperature,
etc). As such, it's important to check your response time and leave
sufficient clearance to avoid any collision. When parking for the first
time, find out the ideal stopping distance for your vehicle and adjust
the stopping distance setting or mounting location, if necessary.
You can use either screws to hang the Garage Parking Sensor
(through the keyhole slots on the rear), or double-sided adhesive pads
to stick the Garage Parking Sensor on the wall surface.
Note: If you are mounting to brick or concrete wall using screws, it's
recommended to also use appropriate wall plugs.
Placement Tip: While the exact location for mounting the Sensor will
vary across all vehicles, it's ideally installed at the same level as the
car bumper, along the wall facing the center of the parking space.
Settings 1 ft 2 ft 3 ft Timeout
Detection zone
2-5 ft 3-5 ft 4-5 ft 20 seconds
Slowdown zone
1-2 ft 2-3 ft 3-4 ft 10 seconds
Stop zone
1 ft 2 ft 3 ft 15 seconds
Loading ...