Loading ...
2/4
When the siicer is not working, the slicer thickness
control 2 must be set on zero (fuIly clockwise) to prevent
the blade edge from being exposed.
Always UNPLUG the power cord before cleaning or moving
the slicer.
SLICING
PuII the product holder 3 towards you until it stops
and place the product to be sliced on the product holder
tray. Place the last slice device against the product and
start the slicer by pressing the on-off swtich 9 . Adjust the
slice thickness by turning the slice thickness control. The
numbers on the slice thickness control do not indicate
precise measurement, but may be used for reference to
duplicate slice thickness. Using either the carriage handle
13 or Iast slice device 4 push the product holder 3
back and forth to slice. Always swtich-off the slicer and
turn the slice thickness control clockwise to zero when
not slicing.
WARNING: Slicer should not be operated by untrained
personnel or persons under 18 years of age.
CLEANING
This machine must be thoroughly cleaned after each day’s
operation or every time it will not be used for an extended
period.
WARNING: UNPLUG MACHINE POWER CORD
AND TURN THE INDEX KNOB FULLY CLOCKWISE
BEFORE CLEANING THE SLICER.
Remove the slice deflector 12 by removing its thumb
screw.
The product holder can be removed for an easy cleaning
by unfastening its handle 8 .
Using a mild soap and hot water solution and a clean cloth,
wipe all surfaces of the slicer.
Thoroughly rinse it with another clean cloth and fresh water.
Remove the blade cover by removing
the hand knob 7 . With the hand knob removed, grasp
the edge of the blade cover and carefully lift it straight off
the knife.
WARNING: THE SLICER BLADE IS VERY SHARP USE
EXTREME CAUTION WHEN WORKING NEAR THE
BLADE.
CAREFULLY wash both sides of the blade with the slice
thickness control turned fully clockwise. Wash the blade
by wiping outward from the centre. ALWAYS rinse the
blade thoroughly using fresh water and a clean cloth. Never
use steel pads it clean the blade. Wash and thoroughly
rinse the removed components prior to reassembling them.
DO NOT wash any slicer components in a dishwasher.
Loading ...
Loading ...