Loading ...
Loading ...
Loading ...
Positive Terminal Negative Terminal Hood
Headlight
Wire
',onnector
Positive ferminal
Charged
Battery
Negative Terminal ENGINE
TO REPLACE HEADLIGHT BULB
o Raise hood.
• Pull bulb holder out of the hole in the
backside of the grill.
• Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill.
o Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
• Check wiring. See electrical wiring dia-
gTam in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
• Raise flood.
o Unsnap headlight wire connector.
o Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
• To replace, reverse above procedures.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
rnent is necessary, proceed as follows:
° With engine not running, move throttle
control lever from slow to choke posi-
tion. Slowly move lever from choke to
fast position.
o Check that holes "A" in governor control
lever and hole in governor plate line-up.
If holes "A" are not aligned, loosen
clamp screw and move throttle cable
until holes are aligned. Tighten clamp
screw securely.
Governor Governor
Control Lever Control Plate
O
Holes "A"
Clamp
Screw
Throttle
Cable
26
Loading ...
Loading ...
Loading ...