Loading ...
Loading ...
Loading ...
- 8 -
HOW TO INSTALL
Note: Top rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of the unit
(5/16”). This is necessary for proper condensed water utilization and drainage. If you are not using the Side
Panels for any reason, this pitch to the rear must be maintained.
1. Place unit on the floor, a bench, or a table. There is a Left and Right Window Filler Panel – be sure to use the
proper panel for each side. When installed, the flange for securing the panel in place to the windowsill will be facing
into the room.
FIG.3C
3: Align the hole in the top rail with those in the top
of the unit as shown in Figure B.
4: Secure the top rail to the unit with the 3/8”
screws as shown in Figure C.
Note: For safety reasons, all four (4) screws MUST
be securely fastened.
Hold the accordion panel in one hand and
gently pull back the center to free the open
end. See Figure 2
Slide the free end of the panel into the
cabinet as shown in Figure 3A, 3B, and 3C.
Slide the panel down. Be sure to leave
enough space to slip the top and bottom
of the frame into the rails on the cabinet.
Loading ...
Loading ...
Loading ...