Loading ...
Loading ...
Loading ...
QUICK START GUIDE
7
u-line.com
4. Upon removal, lay gasket down on a flat surface.
NOTICE
If the door/drawer houses the display, make
certain the display cable remains securely
seated in the inner door channel, see below.
5. The panel should be aligned with the outside edge
(opposite the hinge, if equipped) and high enough to
align with the highest point in the door/drawer.
NOTICE
Due to differences in floor construction or
surrounding cabinetry, the panel may not sit
flush with the top of the door/drawer.
6. Secure integrated
panel to door/
drawer using
clamps. A robust
tape may also be
used. U-Line
recommends the
use of bar clamps
to secure the panel
to the door/drawer.
If using tape, be
certain the tape will
not damage panel
finish upon
removal.
7. Using a 7/64"
(3 mm) drill bit,
drill 6 pilot holes
into the wood panel
1/2" (12 mm) deep using the holes in the door/drawer
frame as a guide.
NOTICE
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed.
8. Locate 6 of the #6x 1-1/2" (38 mm) screws provided
with your unit.
9. Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not overtighten
screws.
Display
Cable
Inner Door
Channel
Align Panel
Against
Door/Drawer
Edge First
Align Top Of Panel With Highest Point Of Door/Drawer
Door/Drawer
Panel
Wood
Panel
Door/Drawer
Bar
Clamp
Bar
Clamp
Loading ...
Loading ...
Loading ...