Loading ...
Loading ...
Loading ...
48
PROBLEM POSSIBLE CAUSES SOLUTIONS
No sound
from button
press or
end of cycle
notification
• The chime feature has been
muted
• Press and hold the Wash Temp
button for 3 seconds to unmute
the chime (on some models). Once
unmuted, the sound from the button
press and end of cycle reminder will
both be restored.
Dryer runs
but won’t
heat
• If 1 of the 2 fuses in the dryer
circuit is blown, the drum
may turn but the heater will
not operate (electric models).
• Gas supply valve is not open
(gas models).
• Dryer does not have enough
air supply to support the
burner flame (gas models).
• LP gas supply tank is empty
or there has been a utility
interruption of natural gas
(gas models).
• Replace fuse.
• Check to make sure supply valve is
open. See
Installation
section for
procedure.
• See
Installation
section.
• Refill or replace tank. Dryer should
heat when utility service is restored.
Drying cycle
takes too
long
Outside of
the
dryer feels
too hot or
smells hot
• Lint filter is clogged with lint.
• Exhaust duct requirements
have not been met.
• Electric dryer is connected to
a 208 volt circuit.
• Drying procedures not
followed.
• Outside exhaust hood or
exhaust duct may be clogged
or restricted.
• High humidity.
• Make sure all lint has been removed
from the dryer lint filter before
starting each cycle.
• Exhaust duct must be at least 4
inches in diameter and made of rigid
or semi-rigid metal.
• When in place, the duct must have
no more than three 90° bends and
must not exceed length listed in
Installation
section.
• Drying time will be 20% longer when
drying on a 208 volt circuit than
when drying on a 240 volt circuit.
• See Operating Instructions.
• Clean out any obstruction.
• Use a dehumidifier near the dryer.
Before Calling (continued)
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...