Loading ...
Loading ...
Loading ...
OPERATION
BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL
• The engine in yourtractor has been shipped, from the
factory, already filled with summer weight oil.
• Check engine oil withtractor on level ground.
• Remove oilfill cap/dipstick and wipe clean, reinsert the
dipstick and screw cap tight, wait for a few seconds,
remove and read oil level. If necessary, add oil until
"FULL" mark on dipstick isreached. Do not overfill.
• For cold weather operation you should change oil for
easier starting (See "OIL VISCOSITY CHART" in the
Customer Responsibilities section ofthis manual).
• To changeengine oil,see theCustomer Responsibilities
section in this manual.
ADD GASOLINE
• Fillfuel tankto bottom offiller neck. Do not overfill. Use
fresh, clean, regularunleaded gasolinewitha minimum
of 87 octane. (Use of leaded gasoline will increase
carbon and lead oxide deposits and reduce valve life).
Do not mixoilwithgasoline. Purchase fuel inquantities
thatcan be used within30 days toassure fuel freshness.
CAUTION: Wipe off any spilled oil or
fuel. Do not store, spill or use gasoline
near an open flame.
IMPORTANT: WHEN OPERATING IN TEMPERATURES
BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE
GASOLINE TO HELP INSURE GOOD COLD WEATHER
STARTING.
__) CAUTION: Alcohol blended fuels(called
gasohol or using ethanol or methanol)
can attract moisture which leads tosepa-
ration and formation of acids during
storage. Acidic gas can damagethe fuel
system ofan engine while in storage. To
avoid engine problems, the fuel system
should be emptied before storage of 30
days or longer. Drain the gas tan k,start
the engine and let it run until the fuel
lines and carburetor are empty. Use
fresh fuel next season. See Storage
Instructions for additional information.
Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
TO START ENGINE (See Fig. 6)
When starting theengine for thefirst time oriftheengine has
run out of fuel, itwilltake extra cranking time to move fuel
from the tank tothe engine.
• Sit on seat in operating position,depress clutch/brake
pedal and set parking brake.
• Place gear shift lever in neutral (N) position.
• Move attachment clutchto "DISENGAGED" position.
• Move throttle controlto fast position
• Pullchokecontroloutfor a coldengine start atternpt.For
a warm engine start attempt the choke controlmay not
be needed.
NOTE: Before starting, read the warm and cold starting
procedures below.
• Insert key into ignition and turn key clockwise to
"START" position and release key as soon as engine
starts. Do not run starter continuously for more than
fifteen seconds per minute. If the engine does not start
after several attempts, push choke control in, wait afew
minutes and try again. If engine still does not start, pull
the choke control out and retry.
WARM WEATHER STARTING (50° F and above)
• When engine starts, slowly push choke control in until
the engine begins to run smoothly. If the engine starts
to run roughly, pull the choke control out slightly for a few
seconds and then continue to push the control in slowly.
• The attachments and ground drive can now be used. If
the engine does not accept the load, restart the engine
and allow itto warm upfor one minute using the choke
as described above.
COLD WEATHER STARTING (50 ° Fand below)
• When engine starts, slowly push choke control in until
the engine begins to run smoothly. Continue to push the
choke control in small steps allowing the engine to
accept small changes in speed and load, until the choke
control is fully in. Ifthe engine starts to run roughly, pull
the choke control out slightly for a few seconds and then
continue to push the control in slowly. This may require
an engine warm-up period from several seconds to
several minutes, depending on the temperature.
• The attachments can be used during the engine warm-
up period and may require the choke control be pulled out
slightly.
NOTE: If at a high altitude (above 3000 feet) or in cold
temperatures (below 32 F)the carburetor fuel mixture may
need to be adjusted for best engine performance. See "TO
ADJUST CARBURETOR" in the Service and Adjustments
section of this manual.
13
Loading ...
Loading ...
Loading ...