Loading ...
Loading ...
Loading ...
15
English
Troubleshooting Guide
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
FOR MORE SERIOUS OR PERSISTENT PROBLEMS,
CONTACT A CRAFTSMAN SERVICE CENTER OR CALL 1‑888‑331‑4569.
WARNING: To reduce the risk of serious personal injury,
ALWAYS disconnect battery pack from tool beforeall repairs
Symptom Cause Fix
Tool doesn’t turn on
(Worklights don’t turn on)
Tool internal electronics not reset Remove battery, wait 3seconds and reinsert
Low battery charge or damaged battery Charge or replace battery
Terminals are dirty or damaged See authorized service center
Bent contact trip See authorized service center
Damaged internal electronics See authorized service center
Tool doesn’t actuate
(Worklights on, motor does
not run)
Motor stops running after 4seconds Normal operation; release trigger or contact trip
and redepress
Contact trip or trigger not depressed See instruction manual
Damaged trigger See authorized service center
Bent contact trip See authorized service center
Damaged internal electronics See authorized service center
Tool in sequential mode and only
trigger being actuated.
Change mode or depress contact trip in
sequentialmode.
Tool doesn’t actuate (Left
worklight flashes 4times)
Low battery charge or damaged battery Charge or replace battery
Tool doesn’t actuate
(Right worklight flashes
continuously)
Jammed fastener Remove the battery, clear the jammed fastener,
(push driver blade back using the stall release lever)
and reinsert battery pack
Jammed mechanism See authorized service center
Tool doesn’t actuate
(Worklights on, motor runs)
Damaged internal electronics See authorized service center
Tool doesn’t actuate
(Worklights on, motor runs,
driver blade stuck down)
Damaged return system Replace return system; see authorized service
center
Debris in nosepiece Clean nosepiece
Damaged driver/return assembly Replace driver/return assembly; see authorized
service center
Tool operates, but does not
drive the fastener fully
Low battery charge or damaged battery Charge or replace battery
Depth adjustment set too shallow Rotate depth adjustment wheel to a deeper setting
Tool not firmly applied to workpiece See instruction manual
Material and fastener length too
rigorous an application
Choose appropriate material or fastener length
Damaged or worn driver blade tip Replace driver/return assembly; see authorized
service center
Damaged or worn driver/return
assembly
Replace driver/return assembly; see authorized
service center
Loading ...
Loading ...
Loading ...