Loading ...
Loading ...
Loading ...
10.4 REPLACE THE SPOOL
1. Push the tabs (2) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover (1).
3. Remove the remaining spool.
4. Clean dirt and debris from all parts. Replace spool if it is
worn or damaged.
5. Replace with a pre-wound spool, or replace the cutting
line.
2
1
3
4
6. Put the new spool (3) in the spool housing (4).
NOTE
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
7. Put the ends of the cutting lines through the holes.
8. Extend the cutting line to release it from the guide slot in
the spool.
9. Push the tabs and install the spool cover onto the spool
housing.
10. Push the spool cover until it clicks into position.
10.5 REPLACE THE CUTTING LINE
NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 0.08" (2 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into the
slot in the center rim of the spool. Make sure that the line
snaps into position in the slot.
3. With your finger between the lines, wind the lines equally
and tightly around the spool in the indicated direction.
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
11
English
EN
Loading ...
Loading ...
Loading ...