OPTIONAL TABLE ASSEMBLY INSTRUCTIONS
This patio heater comes with an optional table assembly that may be installed on the heater. If you wish
to install this feature, please follow the instructions below (no tools required for assembly):
FIG 1: Slide 1 piece part B over part A and up to
the top of part A.
FIG 2: Insert part A through hole in part C.
FIG 3: Slide 1 piece part B over part A until it is
flush against the underside of part C.
FIG 4: Screw part D onto end of part A and up until
it is flush with the underside of part C.
FIG 5: Slide part E down over pole, then slide table
assembly over pole and stop at desired height.
FIG 6: Screw part E over part A to secure table in
position. Once table is at desired height, tighten
part E.
FIG 1
FIG 2
FIG 3
FIG 4
FIG 5
FIG 6
