Loading ...
Loading ...
Loading ...
[] Oncethebladehasmadecontactwiththeworkpiece, []
usethehandclosesttotheripfenceto guideit. Make
suretheedgeoftheworkpieceremainsin solidcontact []
withboththeripfenceandthesurfaceofthetable.If
rippinga narrowpiece,usea pushstickto movethe []
piecethroughthecutandpasttheblade. []
[] Whenthecutismade,turnthesawoff.Waitforthe
bladeto cometo a completestopbeforeremovingthe
workpiece.
BEVELRiP CUT
BLADE
ANGLED
RiP FENCE
PUSHSTICK
[]
Set the miter gauge to the desired angle and tighten
the lock knob.
Make sure the wood is clear of the blade before turning
on the saw.
Turn the power switch to the on position.
Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest
from the blade should be placed on the workpiece.
When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
COMPOUND(BEVEL)MITERCUT
PLACERIGHT HANDONWORKPIECEAND
MITERGAUGEHERE
Fig. 38
MAKING A COMPOUND (BEVEL) MITER CUT
See Figure 39.
It is recommended that you place the piece to be saved
on the left side of the blade and that you make a test cut
on scrap wood first.
dt_ WARNING: Make sure the blade guard assembly
is installed and working properly to avoid possible
serious injury.
[] Remove the rip fence by lifting the locking lever.
[] Unlock the bevel locking lever.
[] Adjust the bevel angle to the desired setting.
[] Lock the bevel locking lever.
[] Set the blade to the correct depth for the workpiece.
Fig. 39
30
Loading ...
Loading ...
Loading ...