Loading ...
Loading ...
Loading ...
7. Engagetriggeriockonspraygunandstartengine
foliowinginstructionsHow to Start Your Pressure
Washe_
8A. If using cleaning tank, rotate detergent shut=off valve on
cbaning tank to ""On"position (A).
/
j/
IMPORTANT:if using detergent siphoning hose, make sure
detergent shut-off valve on cleaning tank is in the "Off"
position.
8B. If using detergent siphoning hose, piacesmaii fiiter end
of detergentsiphoning tube into detergent container.
NOTICE
Contact with the hot muffler can damage detergent
siphoning tube.
Wheninee!tingthe filterinto a detergentsolutionbottle,route
the tubeso asto keepit from inadvertentlycontactingthe hot
rnuffier.
NOTE:Makesure the filter is fully submerged in detergent
while appiying detergent.
9. Apply detergentto a dry surface, starting at iower
portion of area to be washedand work upward, using
long, even, overiapping strokes.
10. Aliow detergentto "soak in" for 3=5 minutes before
washing and rinsing. Re@ptyas neededto prevent
surface from drying. DO NOTaiiow detergentto dry on
(prevents streaking).
IMPORTANT:When using the detergentsiphoning hose, you
must flush the detergent siphoning system after each use by
placing the fiiter into a bucket of ciean water, then run the
pressure washer in low pressure for 1=2minutes.
Pressure Washer Rinsing
After detergent is applied, scenrthe _rface and rinseit clean
as fellows:
1. If using cleaning tank, rotate detergent shut-off valve on
cleaning tank to "Off" position.
2. Rotate PrecisionSprayTM Selector to a high pressure
position, as described in the PrecisionSprayTM Selector
instruction sheet.
3. Keepspray gun a safe distance from spray surface.
WARNING
Kickbackfrom spray gun can causeyou to fall.
o Operatepressurewasherfrom astablesurface.
o BeextrerneIycarefulif you mustusethe pressurewasherfrom
a ladder,scaffolding,or anyothersimilarlocation.
• Firmlygraspspraygun withboth handswhenusing high
pressuresprayto avoidinjury whenspraygunkicks back.
4. Apply a high pressure spray to a small areaand then
check the surface for damage.If no damage,proceed to
step 5.
Start at top of areato be rinsed, working down with
same overiapping strokes used for cleaning.
Cteaning Detergent $iphening Tube
If you used the detergentsiphoning tube, you must flush it
with clean water before stopping the engine.
1. Engagetrigger iock on spray gun.
2. Piacedetergent siphoning tube/filter in a bucket full of
ciean water.
.
5.
Rotate PrecisionSprayTM Selector to a iow pressure
position, as described in the PrecisionSprayTM Selector
instruction sheet.
Fiushfor 1-2 minutes.
Shut off engine foliowing instructions How to Stop
Pressure Washerand turn off water supply.
6. ALWAYS point gun in a safe direction and squeezespray
gun trigger to releaseretained high water pressure.
IMPORTANT:Spraygun traps high water pressure,evenwhen
engineis stopped and water is disconnected.
WARNING
The high pressurestream of water that this
equipment produces can cut through skin and its
_ nderlying tissues, ieadingto serious injury and
}ossibte amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keephigh pressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
o ALWAYSpointspraygunin safedirectionand squeezespray
guntrigger,to releasehigh pressure,everytime you stop
engine.Engagetrigger lockwhennot in use.
autematic Ceel Dewn System {Thermal lleiief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F. The system engagesto cool the pump by discharging
the warm water onto the grnnnd.
13
Loading ...
Loading ...
Loading ...