Loading ...
Loading ...
Loading ...
Installation
57
EN
The nozzles not provided are available at Authorised Service Centres.
5.7 Electrical connection
General information
Check the mains characteristics against the
data indicated on the plate.
The identification plate bearing the
technical data, serial number and brand
name is visibly positioned on the appliance.
Do not remove this plate for any reason.
Perform the ground connection using a wire
that is 20 mm longer than the other wires.
The appliance can work in the following
modes: 220-240 V 1N~
Use a 3 x 1 mm² three-core cable.
Fixed connection
Fit the power line with an omnipolar circuit
breaker in compliance with installation
regulations.
8 LPG G30/31 - 50 mbar AUX SR R UR2 (int + ext) UR3
Rated heating capacity (kW)
1.10 1.70 3.10 1.10 + 3.90 3.30
Nozzle diameter (1/100 mm)
48 54 73 42 + 82 76
Reduced flow rate (W)
400 450 750 400 + 1400 1400
Primary air (mm)
222 2 + 5 2.5
Rated flow rate G30 (g/h)
80 124 225 80 + 284 240
Rated flow rate G31 (g/h)
79 121 221 79 + 279 236
9 Town gas G110 – 8 mbar AUX SR R UR2 (int + ext) UR3
Rated heating capacity (kW)
1.10 1.70 3.10 1.10 + 3.80 3.30
Nozzle diameter (1/100 mm)
132 165 240 132 + 290 250
Reduced flow rate (W)
400 450 750 400 + 1200 1400
Primary air (mm)
1 1 1 1.5 + 4 2
Power voltage
Danger of electrocution
• Have the electrical connection
performed by authorised technical
personnel.
• Use personal protective equipment.
• The appliance must be connected to
ground in compliance with electrical
system safety standards.
• Disconnect the mains power supply.
• Do not pull the cable to unplug the
appliance.
• Use cables withstanding a temperature
of at least 90 °C.
• The tightening torque of the screws
of the terminal board leads must be
1.5 - 2 Nm.
The values indicated above refer
to the cross-section of the internal
lead.
Loading ...