Loading ...
Loading ...
Loading ...
If connecting by direct wire:
Power supply cable must match power supply (4-wire or 3-wire)
and be:
a Flexible armored cable or nonmetallic sheathed copper cable
(with ground wire), protected with flexible metallic conduit. All
current-carrying wires must be insulated.
= 10-gauge solid copper wire (do not use aluminum).
= At least 5 ft (1.52 m) long.
GROUNDING INSTRUCTIONS
= Fora grounded, cord-connected dryer:
This dryer must be grounded. In the event of malfunction or
breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This dryer uses a cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged
intoan appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
= Fora permanently connected dryer:
This dryer must be connected to a grounded metal,
permanent wiring system, or an equipment-greunding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead on
the dryer.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative
or personnel if you are in doubt as to whether the dryer is
properly grounded. Do not modify the plug on the power
supply cord: if it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
SAVE THESE INSTRUCTIONS
Electrical Requirements- Canada Only
Electrical Shock Hazard
Plug Into a grounded 4 prong outlet.
Failure to do so can result In death or electrical shock.
m TOsupply the required 4 wire, single phase, 115/230-volt,
6O-Hz., AC-only electrical supply on a separate 30-arnp
circuit, fused on both sides ofthe line. A time-delay fuse or
circuit breaker is recommended. Connect to an individual
branch circuit.
= This dryer is equipped with a CSA International Certified
Power Cord intended to be plugged into a standard 14-30R
wall receptacle. The cord is5 fc(1.52 m) in length. Be sure
wall receptacle is within reach of dryer's final location.
©
4-wire receptacle 14-30R
= Do nat use an extension cord.
If using a replacement power supply cord, it is recommended
that you use Power Supply Cord Replacement Part Number
9831317. Forfurther information, please reference the service
numbers located inthe "Assistance or Service" section on this
manual.
GROUNDING INSTRUCTIONS
= Fora grounded, cord-connected dryer:
This dryer must be grounded. In the event of malfunction or
breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This dryer is equipped with a cord having an equipment-
grounding conductor and a grounding plug.The plug must
be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes
and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative
or personnel if you are in doubt as to whether the dryer is
properly grounded. Do not modify the plug provided with the
dryer: if itwill not fitthe outlet, have a proper outlet installed
by a qualified electrician.
SAVE THESE INSTRUCTIONS
It isyour responsibility
a Tocontacta qualifiedelectricalinstaller,
m To be sure that the electrical connection isadequate and in
conformance with the Canadian Electrical Code, C22.1-1atest
edition and all local codes. A copy ofthe above codes
standard may be obtained from: Canadian Standards
Association, 178 Rexdale Blvd., Toronto, ON Mgw 1R3
CANADA.
8
Loading ...
Loading ...
Loading ...