Loading ...
Loading ...
Loading ...
Section 3: Assembly
BEFORE STARTmNG THE
ENGmNE
[ne Oil
° Race genera[or on a level surface.
1
• Refer to engine manuaIfor oil fill information.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
° Refer to engine owner's manuaHand follow oiH
recommendations and instructions.
NOTE: Check oiH often during engine break-in. Refer to
engine owner's manual for recommendations.
NOTE: The generator assembly rotates on a prehbricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.
Add Fuel
NOTE:This gasoline engine is certified to operate on
gasoline.Exhaust Emission Control System: EP1(Engine
Hodifications).
WHEN ADDING FUEL
Turn generator OFF and let is cool at [east 2 minutes before
removing fueJ cap, Loosen cap slowly to relieve pressure in
_:anI<,
Fillfueltank outdoors,
DO NOT overfill tank.AHow space for" fuel expansion.
Keep fueI away from sparks, open flames, pilot lights, heat, and
other ignition sources
DO NOT light a cigarette or smoke.
1
[. Use c[eam fresh, regular UNLEADED fuel with a
minimum of 85 octane. DO NOT use fuel which
contains HethanoL DO NOT mix oil with fuel
2. Clean area around fuel fill cap_ remove cap.
3. Slowly add regular unleaded fuel to fuel tank. Be careful
not to overfill.Allow about 2.25" of tank space for fuel
expansion (Figure 2).
Fuel
4.
Replace "1.5" with "2.25" fuel fill level given in engine manual
FaiIure I:o follow this instruction may cause fueI _:o overexpand
and spillfrom _:anl<,
Instal[ rue[ cap and wipe up any spiHed fuel
Remove Cover on Stare Switch
A protective plastic cover is placed over the start switch to
prevent the generator from being started.
° Open cap on battery float charger.
° Remove and discard plastic cover over the start switch
(Figure 3).
o Replace cap on battery float charger.
O
Loading ...
Loading ...
Loading ...