Loading ...
Loading ...
Loading ...
English
4
A ......................... amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n
o
.......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
Intended Use
This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoorfurniture.
DO nOT use under wet conditions or in presence of
flammable liquids orgases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Assemble Frame Handle (Fig. A–C)
Your pressure washer is not fully assembled in the carton.
1. To assemble the frame handle
14
to the pressure
washer unit
7
, line the upper poles
15
with the lower
poles
16
so the detent pins snap intoposition.
Fig.B
15
16
Fig.C
14
7
Specifications
Maximum Pounds per Square Inch 2,400
Rated Gallons per Minute* 1.1
Electrical Requirements 120V
AC
~60Hz, 13A
Electrical Cord 35 ft. (10.6 m)
High Pressure Hose 25 ft. (7.6 m)
Minimum Amp Source 15A
Pressure of Inlet Water* 20-100 PSI
Inlet Water Cold Tap
Soap Consumption Rate 10% MAX
*Water flow and maximum pressure ratings determined in accordance with
CETA CPC-100.
High Pressure Hose Storage Hook (Fig. D)
Your pressure washer is not fully assembled in the carton.
1. To assemble the high pressure hose storage hook
17
to the crossmember
19
, squeeze the detent end
18
of
the hook so it will slide between the retaining slots
31
on the rear of the crossmember
19
.
2. Release the pressure hose storage hook
17
allowing the
detents
18
to rest securely in the retaining slots
31
.
3. Press the high pressure hose storage hook
17
onto the
locking detents
32
on the rear of the crossmember
19
until it clicks into place.
Fig.D
17
18
19
31
32
Loading ...
Loading ...
Loading ...