HeatFast HF215K User Manual

Loading ...

-9-

WARNING: Never leave the heater unattended while operating.

Disconnect the heater from its power source when not in use.

BEFORE OPERATING THIS HEATER

Visually inspect for damage. Some parts may have become loose or were damaged from handling. Be certain the fuel cap is

securely fastened and check that the drain plug (if applicable for your model) is installed properly. Replace or repair any damaged

parts before operang this heater. USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use of third party or other alternate

components will void the warranty and may cause unsafe operang condions. If you need replacement parts or require assistance,

contact PowerFast Product Group at (423) 837-5155.

AIR INTAKE FILTER

Dirty Intake Filters can cause an imbalance in the fuel-to-air mixture, resulng in

rough starng, poor combuson and odors. Never operate a heater without the

lters in place.

Remove and wash the intake with a mild detergent and water. Thoroughly dry and

replace the lter. Clean the lters every 500 hours as needed.

AIR OUTPUT FILTER AND LINT FILTER

The Output and the Lint Filter are not designed to be cleaned and reused. Do not

wash these lters. Replace dirty lters at the start of each season.

REPLACING AIR FILTERS

1. Remove Upper Shell and Fan Guard.

2. Remove End Filter Cover screws using a medium Phillips screwdriver.

3. Remove End Filter Cover.

4. Replace the Air Intake Filter, Air Output Filter, and Lint Filter.

5. Reinstall End Filter Cover.

6. Reinstall Fan Guard and Upper Shell.

PHOTOCELL

The opcal lens can become dirty or clouded in use. Clean the lens using isopropyl

alcohol or water and a so cloth or coon swab every 500 hours or as needed.

REPLACING THE PHOTOCELL

1. Remove Upper Shell.

2. Remove Right Side Panel.

3. Disconnect wires from circuit board (PCB).

4. Twist to loosen Photocell from the Photocell Bracket.

5. Clean lens or replace Photocell.

6. Insert Photocell into Photocell Bracket.

7. Properly align the Photocell within the Bracket.

8. Aach wires to circuit board.

9. Reinstall Right Side Panel.

10. Secure Upper Shell.

Lint Filter

Air Out Put Filter

Intake Filter

End Filter Cover

Improper Alignment Proper Alignment

Loading ...

HeatFast HF215K Oil Fired Forced Air Construction Heater