US Stove US3200E-P Owner’s Instruction and Operation Manual

Loading ...

Notice: Use solid wood fuel only! Do not burn garbage,

or flammable fluids. Do not use coal. This appliance

is not designed to accommodate the air flow (draft)

required to properly burn coal or coal products. Do

not elevate the fire using grates or irons. Build the fire

directly on the firebrick.

FUELING INSTRUCTIONS

This wood stove has been certified by the US EPA

to meet strict 2020 guidelines. To ensure this unit

produces the optimal minimum emissions it is critical

that only well-seasoned cordwood is burned (see the

“Fuel Recommendations” section of this manual).

Burning unseasoned wet wood only hurts your stoves

eciency and leads to accelerated creosote buildup in

your chimney. Be considerate of the environment and

only burn dry wood.

CAUTION:

DO NOT LEAVE APPLIANCE UNATTENDED THE

WITH DOOR OPEN.

For a cold start-up, place 4 to 5 pieces of newspaper

into the firebox. On top of the newspaper, lay 5 lbs of

kindling in a random placement to ensure airflow through

the kindling. On top of the kindling, place approximately

6.5 lbs of small pieces of cordwood. NOTE: Use smaller

pieces of wood during start-up and a high burn rate to

increase the stove temperature.

6.5 lbs

Push both air control slides to the fully open position.

Light the newspaper and close the door. Once the kindling

has burned down to a starter coal bed, load the unit with

approximately 26 to 27 lbs of fuel for the first high burn

load.

26 to 27 lbs

After the first high burn load and the stove is well warmed

up, adjust the unit as needed for a medium or low burn

setting. For a medium burn, once the high burn fuel load is

burned down to an established coal bed, load the unit with

31 to 32 lbs of cordwood and keep the door slightly open

for 2 minutes. After two minutes close the door. Keep the

secondary airslide fully open for 10 minutes then close

completely and set the primary airslide halfway closed.

At the 15 minute point of loading your fuel, the primary

air slide should be set at the medium setting which is

about 1/2 inch open from the fully closed position.

31 to 32 lbs

For a low burn setting once the high burn (or medium)

fuel load is burned down to an established coal bed, load

the unit with 31 to 32 lbs of cordwood and leave the door

open for two minutes. After two minutes close the door.

Keep the secondary airslide fully open for 10 minutes then

close completely and set the primary airslide halfway

closed. At the 15 minute point of loading your fuel, the

primary air slide should be set at the low setting which

is pulling the airslide completely out toward you. NOTE:

Do not close the air too quickly. Closing the air too quickly

will cause the unit to smoke.

OPERATION INSTRUCTIONS

Loading ...

US Stove US3200E-P 3,200 Sq. Ft. Large Pedestal Wood Stove with Blower

Owner’s Instruction and Operation Manual - Page 13