Loading ...
Loading ...
Loading ...
Aboutthe controlswith
temperaturesettings.(for other models, see next page) GEAppl_nce_com
t
NOTE,"Therefrigeratoris shipped with protective film covering the temperaturecontrols.
If this film was not removed during installation, removeit now
The temperature controls are preset in the factory at 37°1:for the refrigerator compartment
and #OFfor the freezer compartment. Allow 24 hours for the temperature to stabilize to the
preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly from
the SET temperature based on usage and operating environment.
Setting either or both controls to OFFstops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
Changing the Temperature
To change the temperature, press and release the
WARMER or COLDER pad. The SETlight will c(:,me
on and the display will show the set temperature.
To change the teml)eratm'e, tn l) either the
WARMER or COLDER pad until the desired
teilll)erattlre is displayed, Refl'igerator teml)erattlres
can be a(!iusted between 34°F and 47°F and the
fl'eezer teInI)eratures can be ac!iusted between
-6°F and +8°E
Once the desired temperature has been set,
the temperatm'e display will return to the actual
refi'igei'ator and fl'eezer teml)erattlres afiei" 5
seconds, Several ac!iustments may be required,
Each time you a(!just controls, allow 24 horns fiw the
refl_igerator to reach the temperatm'e you have set.
Toturn the cooling system off, tnI) the WARMER pad
fro" either the refl_igerator or the fl'eezer until the
display shows OFF.To turn the unit back on, press the
COLDERpad fl)r either the refl_igerator or fl'eezei;
The SErlight will illuminate on the side you
selected. Then press the COLDERpad again (on the
side where the SETlight is illuminated) and it will
go to the preset points of O°Fflw the fi'eezer and
37°Ffi)r the refl-igeratm; Setting either or both
controls to OFFstops cooling in both the fi'eezer
and refi-igerator compartments, but does not shut
off electrical power to the refl_igeratm;
Performance A# Flow System
The Pedbm_an('e _Mr Flow System is designed to
maMmize temperature control in the refl_igerator
and fl'eezer conq)artmei_ts. This tmique special
teatm'e consists of the _dr Tower along the back
wall of the refrigerator and the _Mr Tmmel on the
bottom portion of the fl'eezer rear wall. Placing
fi)od in fl'ont of the lou\'e_s on fl_ese components
will not affect i)eHbm_ance.
Loading ...
Loading ...
Loading ...