Loading ...
Loading ...
Loading ...
Tool Required
• Two 9/16” Wrenches
• Two 1/2" Wrenches
• Two 16 mm Wrenches
Unpack and Assemble Powerhead (SEE FIGURE 3.)
1. Carefully lift the powerhead out of the box, remove any
packing material and cut any ties.
2. Place the handle bar grip onto the frame.
3. Secure with two 5/16-18 x 1 1/2" inch bolts.
4. Install spring lock washers and lock nuts and tighten.
Repeat for all handles.
5. Insert the output shaft of the transmission in the open end
of the Flex Coil Shock Top.
6. Line up the bolt holes through the Flex Coil Shock Top and
the output shaft of the transmission.
7. Install the 3/8-16 x 1 1/2" inch (Alternate metric Part M10-
1.5 X 35 mm) bolt through the bolt hole.
8. Install the 3/8-16" (Alternate Metric Part M10-1.5 mm) BI-
Way locknut on the bolt.
9. Using two 9/16" inch (or 16 mm on alternate metric parts)
wrenches, tighten the lock nut and bolt.
ASSEMBLY
5/16-18 x 1 1/2”
BOLT
5/16 “
NUT & WASHER
HANDLE
BAR GRIP
TRANSMISSION
OUTPUT SHAFT
3/8-16 X 1 1/2”
(M10-1.5 X 35 MM)
BOLT
3/8”
(M10)
BI-NUT
FLEX COIL SHOCK TOP
THIS SIDE UP
WHEN NOT IN USE
FIGURE 3
8
Operator's Manual
Two-Man Earth Auger Powerhead 9800 Series
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
Loading ...
Loading ...
Loading ...