Loading ...
Loading ...
Loading ...
Step 15.
Using a large container run the water dispenser to clear
air from lines. This may take a few minutes. Purge and
dispense a minimum of 2 litres of water or until the water
runs clear. Initial water may be black in colour. This is
residual carbon dust from the filter and is non-toxic. If the
water is slow to shut off or the dispenser is dripping, air
may still be in the lines. Either purge more water through
the system to remove this air or allow some time for the air
to be removed over subsequent dispensing.
Step 16.
Switch ON Ice Maker.
Step 17.
After 24 hours remove ice bin and dispose of first few
batches of ice to ensure that impurities have been flushed
from the system.
Tips and Useful Information
Ensure that taps are turned off when replacing and
fitting filters. Remember to turn the taps back on
when filter fitting is complete.
Always fit filter as per manufacturer’s instructions,
paying special attention to water flow direction.
If you need to replace water tube, only use
approved water quality piping that meets the
pressure requirements.
Do not allow the water tubing to become kinked
or trapped under the refrigerator when moving the
refrigerator back into position.
Make sure your refrigerator is level to avoid uneven
or oversize cubes. Uneven ice cubes may lead to
the dispenser chute becoming blocked.
After installation, run the water dispenser for a few
minutes to ensure that all air bubbles have been
purged from the tubing. Dripping may occur if air
bubbles remain in the tube.
Replace filter at suggested intervals to avoid water/
ice reduction and irregularities in taste.
Remove and clean ice bin once a month, discarding
unused ice cubes. This will ensure fresh, clean ice
and smooth operation of your ice maker.
Clean and empty the dispenser drip tray regularly to
avoid overflow.
As the water/ice cut off is not instant, leave glass
under dispenser briefly until water or ice has
stopped flowing to avoid spills.
Always place ice in glass before filling with water to
avoid splashing.
When dispensing ice hold the container close to the
chute to avoid spray or spills.
If you have not used the dispenser for some time:
•Discard the first seven or eight cups of water
• Discard any ice that the ice maker produces in the
first 24 hours (contaminants could have settled in the
water pipes)
ICE & WATER INSTALL ATION
14
Loading ...
Loading ...
Loading ...