Loading ...
Loading ...
Loading ...
22
WARNING!
To reduce the risk of tipping the appliance, the appliance must
be secured by properly installed anti-tip device packed with the
appliance.
●
A child or adult can tip the range and be killed.
●
Install the anti-tip device to the structure by fastening
the supplied bracket to the floor and wall following the
instructions for installing the anti-tip device.
●
Engage the anti-tip device.
●
Re-engage the anti-tip device if the range is moved.
●
See installation instructions for details.
Failure to do so can result in death or serious burns to children
of adults.
@1INSTALLING THE ANTI-TIP BRACKET
All ranges must have an anti-tip device correctly installed as per the following
instructions. If you pull the range out from the wall for any reason, make sure
that the device is properly engaged when you push the range back against
the wall. If it is not, there is a risk of the range tipping over and causing injury
if you or a child stand, sit or lean on an open oven door.
Included Parts
(4) #10 x 2” wood screws, (2) 5/16 x 1 -1/2” sleeve anchors, (2) lag bolts and
washers and (1) Anti-tip bracket
Installing the bracket
Instructions are provided for wood and concrete floors. Any other type of
construction may require special installation techniques as deemed necessary
to provide adequate fastening of the Anti-tip bracket to the floor and wall.
The use of this bracket does not preclude tipping of the range when not
properly installed.
Wood substrate
1 Place the bracket against the back wall, into the right rear corner where
the range is to be located. Leave a gap between the wall (or side of range)
and the bracket, as shown.
2 Drill (x2) 1/8” diameter pilot holes in the center of the small holes.
A nail or awl may be used if a drill is not available.
3 Fasten the bracket securely to the floor and wall.
Concrete or cement substrate
1 Locate the bracket as shown.
2 Using the bracket as a template, drill (x2) 5/16” diameter pilot holes
in the center of the larger holes to a depth of at least 1 3/4”.
3 Place the sleeve anchors into the holes and use a hammer to tap them
all the way in.
4 Tighten the nuts on the sleeve anchors to fasten the bracket securely
to the floor.
Once Installed
Check for proper installation of the range and Anti-tip bracket by
grasping the back of the range and carefully attempt to tilt it forward.
Range may vary
(2) Large Holes for
Concrete Installations
1/2”
(13mm)
(2) Small Holes for
Wood Installations
(2) Wood Screws into Back
Wall (ALL Installations)
Right side of
wall or range
Back wall
!
Loading ...
Loading ...
Loading ...