Loading ...
Loading ...
Loading ...
iNSTALLATiON iNSTRUCTiONS
Follow these instructions to install the pedestal on a washer or dryer.
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or ether injury.
4.
Pull the lever up on the left side of the drawer and at the
same time, push the lever down on the right side. While
holding the levers in position, pull the drawer all the way out
and set aside. Push the slides back into the pedestal.
1.
Open the pedestal drawer as far as possible and remove the
contents. This package contains 4, #12 x 5/8"hex head sheet
metal screws used in step 5, and the divider pack.
A. Lever (right side shown)
5. Ifyour washer or dryer has feet installed, remove them. Do
not install the feet that came with a new washer or dryer.
6. Partially install 2 of the #12 x %" hex head sheet metal screws
in the lower holes. Leave a space of about 8/8"(1 cm) between
the screw head and the bottom of the washer or dryer.
A B
2. Verify the 4 spacer pads are installed on the top of the
pedestal.
3.
7.
A. Spacer pads
Locate the levers on the drawer slides on each side of the
drawer.
C C
A.Washerbottom
B.Dryer bottom
C.Install screws
Tip the pedestal on its back and move it against the washer
or dryer bottom. Slide the pedestal's keyhole slots over the
lower 2 partially installed screws.
%
B
A. Drawer slide
B. Lever
A. Lower screws in keyhole slots
8. Position the pedestal toward the front of the washer or dryer
and install the 2 remaining hex-head sheet metal screws. Do
not tighten completely.
9. Align the sides of the pedestal so that they are even with the
sides of the washer or dryer. Reach inside the pedestal
drawer opening and securely tighten all 4 pedestal screws.
Loading ...
Loading ...
Loading ...