Loading ...
Loading ...
Slim Line Series Installation Details:
MODELS MODELS MODELS MODELS
N1900T N1900BP1 N1900BP N1900PS
N1900SD2
CABINET: Be sure that the cabinet bottom is level, side
to side and front to rear. BP & T: Cut an 8” x 8” hole in
the bottom of the cabinet, 3/4” in from the rear wall and
on center line.BP1: Cut an 8” x 8” wide hole that is 4.25”
off center in the bottom of the cabinet, 3/4” in from the
wall. Shelves and top to be cut to clear 7” round pipe to
line up with the bottom cabinet cut out. Also, cut holes
for electrical wires. The location of the cut out deter-
mined by the model you are installing.
ELECTRICAL: Stub enough wire into cabinet to reach in
front of vent pipe. Enter cabinet 2” left (facing hood) of
center and 1-1/8” from wall. Remove electrical box cover
before mounting. SD2 wire goes to the right rear.
Units are to be hard wired
. It is not recommended to
add a power-cord. Adding a power cord can loosen
existing wires inside junction box causing electrical
failure.
MOUNTING: Remove black tape holding dampers
closed. *It is NOT recommended to use 2 dampers
during installation. You have the option to put a
external damper or use the existing damper already
on the unit. Insert canopy below the cabinet, being sure
your vent opening and electrical cut outs line up with
cabinet cut outs. Use the Key Hole mounting holes to
secure the canopy. After hood is mounted attach house
wires to leads in the hood. Secure locknut to conduit and
check wiring for compliance to local building codes.
FINISH: Replace electrical box cover. Connect duct and
tape all joints. Replace Filters.
NOTE: Blower on N1900T is offset to the right with a
center duct. (Majority of airflow will be on the right side)
NOTE: Blower on N1900BP1 is center and duct if offset
to the left.
WARNING: To reduce the risk of fire or electrical shock
DO NOT use the “SD2” series with any solid-state speed
control device.
Duct Sizes Indicated in Model # (Ex: N1942PS-8 )
** - 8
= 8” DUCT PIPE
Ex: N1942PS = 7” Round Duct Pipe
N1900T
N1900BP
N1900PS
N1900SD2
Black Tape on Damper
N1900BP1
Loading ...
Loading ...
Loading ...