Loading ...
Loading ...
Loading ...
116 - CLEANING AND MAINTENANCE 914779723/A
Cleaning the reservoir and the water circuit
Once the descaling solution has been drained,
the appliance starts the cleaning procedure for
the reservoir and the hydraulic circuit.
The display will show the request to fill the
reservoir with water.
1. Fill a jug or a container with approx. 2 litres
of clean water.
2. Open the appliance door.
3. Place the jug (or container) on the open
door.
4. Remove the loading wand from its holder.
5. Place the end of the tube at the bottom of
the jug (or container).
6. Press the start button to start filling the
appliance reservoir with water.
7. When you have finished filling water into the
reservoir, touch the CONFIRM button
to continue with the function.
The appliance starts the function using the
parameters set.
• When cleaning the reservoir and the
hydraulic circuit, leave the jug on the door
open with the loading wand inside. The
appliance cyclically discharges certain
quantities of water used for cleaning.
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
8. After completion of the cleaning process the
request to drain the water is shown on the
display.
9. Clean and dry any residual water inside the
oven cavity.
10.Open the door
11.Place a jug or container on the open door.
12.Remove the loading wand from its holder.
13.Press the START button to start draining
the water into the jug (or container).
14.Wait for the end of the drain flow.
When complete, the display will indicate that
the residual water removal process is complete.
Manual descaling
When you wish to perform descaling in
advance, you can run the function manually:
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu button (located in
the lower area ).
3. Touch the DESCALING button .
4. Proceed with descaling as described in the
previous paragraphs.
Cleaning the reservoir and the water
circuit manually
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu button (located in
the lower area ).
3. Touch the CLEAN RESERVOIR
button.
Preliminary operations
1. Fill a jug or a container with approx. 2 litres
of water.
2. Open the appliance door.
Use cold tap water which is not too
hard, softened water or still mineral
water.
Do not use distilled water, tap water
with a high chloride content (> 40 mg/
l), or other liquids.
The overflowing of water inside the
oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
Function that performs descaling of
boiler.
This function allows you to clean the
reservoir and the water circuit of the
appliance.
Loading ...
Loading ...
Loading ...