Loading ...
Loading ...
Loading ...
Installation Instructions
ROLLERS
The rollers have 3 purposes:
0 Rolle_ a(!just so the door closes easily when opened
about halfway:
O Rollers a(!just so the refl_igerator is firefly positioned
on the floor and does not wobble.
O Rollers allow )ou to moxe the refl_igerator mvay fl'om
the wall fin" cleaning.
To adjust the milers, remove the base grille by pulling it
out at the bottom.
Turn the roller a(!iusting screws clockwise to raise the
refl_igerato_; comlterclocl_vise to lower it. Use an
a¢!iustable wrench (3/8" hex head bolt) or pliers.
To replace base grille, line up the clips on back of grille
between the bar and the bottom of the cabinet. Push
tin'ward until grille snaps into place.
DOOR ALIGNMENT
_dter le\vling, make sure that doo_s are e\'en at the top.
To make the doors even, at!just the refl_igerator
compartment doo_: Using a 5/16" socket wrench, mrn the
door a(!justing screw to the right to raise the (loot; to the
left to lower it. (A nylon plug, embedded in the threads of
the pin, prevents the pin from turning tmless a wrench is
used.) _dter one or two turns of the wrench, open and
close the refi_igerator compartment door and check the
aligmnent at the top of the doot_,
Toremovetbebase
grille,opentbedoors
andthenpulltbe
grillestraightout.
5/16"Socket
Wrencb
INSTALLING THE WATER LINE
BEFORE YOU BEGIN
The water line installation is not warranted bv the
refl'igerator or icemaker mantflacturer. Follow these
recommendations careflfllv to minimize the risk of
expensive water damage.
_'ater hammer (water banging in the pipes) in house
plumbing can cause damage to refl'igerator parts and
lead to water leakage or flooding. Call a qualified
plumber to correct water hammer before installing
the water sui)ply line to the refl'igerator.
To prevent burns and product damage, do not hook
up the water line to the hot water line.
If you use your refi'igerator before connecting the
water line, make sure the icemaker power switch is
in the O (off) position.
BEFORE YOU BEGIN (CONT.)
Do not install the icemaker robing in areas where
temperatures fall below freezing.
When using anv electrical device (such as a power
drill) during installation, be sure the device is
insulated or wired in a manner to prevent the hazard
of electric shock.
All installations must be in accordance with local
plumbing code requirements.
Installation of the icemaker must be done by a
qualified service tech_ficim_.
a, WARNING!C, mnect to p,,table
water suI)ply only.
15
Loading ...
Loading ...
Loading ...