Loading ...
Loading ...
Loading ...
14
DANGER: Carbon Monoxide. Using an engine indoors can kill you in
minutes. Engine exhaust contains high levels of carbon monoxide (CO), a
poisonous gas you cannot see or smell. You may be breathing CO even if you
do not smell engine exhaust.
• Breathing ex haust fumes will cause se ri ous injury or death! En gine exhaust
contains carbon mon ox ide, an odorless and deadly gas.
• Operate pressure washer in a well-ventilated area. Avoid en closed areas
such as ga rages, base ments, etc.
• Never op er ate unit in or near a lo ca tion occupied by humans or animals.
WARNING: Risk of Fire, Asphyxiation and Burn. Never fill fuel tank when
engine is running or hot. Do not smoke when filling fuel tank.
• Never fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below bottom of filler
neck to provide space for fuel expansion. Wipe any fuel spillage from engine and
equipment before starting engine.
• DO NOT let hoses come in contact with very hot engine muffler during or
immediately after use of your pressure washer. Damage to hoses from contact with
hot engine surfaces will NOT be covered by warranty.
NOTICE: Risk of property damage. Never pull water supply hose to move pres sure
washer. This could damage hose and/or pump inlet.
• DO NOT use hot water, use cold water only.
• Never turn water supply off while pressure washer engine is running or damage to
pump will result.
• DO NOT stop spraying water for more than two minutes at a time. Pump operates
in bypass mode when spray gun trigger is not pressed. If pump is left in bypass
mode for more than two minutes internal components of the pump can be
damaged.
If you do not understand these precautions, please contact our customer service
department at 1-844-375-7577.
Before Each Start Up (FIG. 1, 5, 6)
1.
In a well-ventilated outdoor area, add fresh, high-quality, unleaded gasoline with
a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before
starting the engine. Refer to
Engine Owner's Manual
for correct procedure.
NOTICE: Use of fuels with greater than 10% ethanol are
not approved for use in this product per EPA regulations
and will damage the unit and void thewarranty.
2.
Check engine oil level. Refer to the
Engine Owner's Manual
for correctprocedure.
3.
Check pump oil level.
The oil level should come to the dot in the middle of the sight
glass (S, Fig 2).
4.
In a well-ventilated outdoor area, add fresh, high-quality #2 diesel fuel to the burner
fuel tank fill.
5.
Visually inspect all electrical components, hoses, nozzles and guns to assure they
are in good condition. If replacements are necessary they must be rated to withstand
the machines operating pressure and temperatures. See
SpecificationInsert.
6. Verify the filter screen (BB) is in water inlet on the machine. NOTE: Convex
side faces out. Connect the cold water source to pump inlet (L). NOTE: Failure
to use machine without inlet screen filter installed may void warranty.
Loading ...
Loading ...
Loading ...